--------------- A l c o r n --------------- AMI Terminal M c B r i d e --------------- Release Notes I n c . --------------- 2020-05-15 v3.40 ---------------------------------------------------- - Fixed issue that could cause AMI Terminal to not launch under certain conditions. 2018-03-13 v3.38 ---------------------------------------------------- - Added new framerates for Binloop Uncompressed 2017-04-06 v3.37 ---------------------------------------------------- - Added RidePlayer support 2016-01-26 v3.36 ---------------------------------------------------- - Updated VPage "IPDS" command to be "IPDN" 2015-12-07 v3.35 ---------------------------------------------------- - Added VPage IP address set as follows: - To set the IP of VPage, launch the "Find Device" in AMI-Terminal. Note: if IP has already been set, flip up and down the DIP switch #3 on the VPage - Clicking on the item in the "Find Device" window will cause the VPage to blink its lights green - Clicking "OK" after finding device will launch a series of dialogs and status messages for setting the IP. Note: If setting the Dante IP address is also needed, first make sure the address is cleared using the Dante Software. 2015-10-29 v3.34 ---------------------------------------------------- - Added A/V Binloop Uncompressed support - Added device name parameter to VPage - Added 1080p (29.97) to A/V Binloop HD Set Video Format command - Fixed certain show controller get/set buttons that had stopped sending commands - Added "Find Device" button - New Updater Support 2015-07-02 v3.33 ---------------------------------------------------- - Windows XP SP3 compatible 2015-07-02 v3.32 ---------------------------------------------------- - Removed some discontinued products - Updated libraries - New installer - Added VPage