How do I terminate/un-terminate the sync signal on a V16+/V4+/V2+/InterActivator?
There is a jumper near the Video Sync BNC on the circuit board inside each of these products. To terminate the sync signal, make sure the jumper is installed. To un-terminate the sync signal, remove the jumper. When the jumper is installed, it makes a 75Ohm termination.
Remove from favorites
Related Questions
- Do your show controllers sync to SMPTE and EBU timecode?
- What is the difference between a V16+, a V4+, a V2+ and an InterActivator?
- Do you make any products that can control my Videowall?
- Can a V16+ or V4+ be the 'brain' for an entire facility?
- Can I use my CD player with the Show Controller?