This product file is used for M-Series Christie projectors.
Christie “M” Series ASCII
serial
Baud: 115200
Bits: 8
Parity: n
Stop Bits: 1
ethernet
Port: 3002
Type: tcp_client
IP Address: 192.168.100.254
PowerOn – Turns the lamp and all electrical power on.
PowerOff – Set the projector to standby mode.
GetPowerStatus – Returns projector power status into PowerStat variable
Reboot – Reboots the projector into failsafe mode. Note: The projector must be in Standby mode (PowerOff) before initiating this command.
OpenShutter – Opens the shutter.
CloseShutter – Closes the shutter.
GetShutterPosition – Returns shutter position into ShutterPos variable
SetInput – Set the active input for the main video.
GetInput – Returns the current main video input slot number to SlotNum and input number to InputNum variables.
SetBrightness – Adjusts the offset applied to the input signal. (Sets the brighness on main video to the specified value in the range of -1000 to 1000).
GetBrightness – Returns brightness value of the main video to the Brighness variable.
SetContrast – Adjusts the gain applied to the input signal. (Sets the contrast on main video to the specified value in the range of 0 to 1000).
GetContrast – Returns contrast value of the main video to the Contrast variable.
SetColor – Adjusts the saturation (amount) of color in a video image. (Sets the color saturation on main video to the specified value in the range of 0 to 1000).
GetColor – Returns color saturation value of the main video to the Color variable.
SetSize – Controls how much the projector electronically expands or shrinks the image. (Aspect ratio does not change.)
GetSize – Returns the size value on main video to the Size variable.
SetScreenOrientation – Selects the orientation of the displayed image. It an be displayed normally, inverted horizontally, inverted vertically, or inverted in both directions as required by the projector installation.
SetDetail – Adjusts the sharpness (detail) of the image. The sharpness detail enhancement applied is based on adaptive horizontal, vertical, and diagonal large edge and small edge enhancement processes.
Mute/Unmute – Mutes the displayed image (image goes black) or unmutes (image returns) without closing the mechanical shutter. When the image is muted, all DMD mirrors are turned to the off position.
Freeze/Unfreeze – Freezes/unfreezes the display image to allow a detailed examination of a single frame of an otherwise moving image. Switching channels/ inputs automatically switches the projector to unfrozen.
FadeToBlack – Fades the image to black over the time period specified.
FadeBack – Fades back to the image (from black) over the time period specified.
Lamp1Hours – Returns Lamp1_Hours and Lamp1_Minutes into variables.
Lamp2Hours – Returns Lamp2_Hours and Lamp2_Minutes into variables.
Error
TCPStatus
PowerStat “Unknown”
ShutterPos “Unknown”
SlotNum 0
InputNum 0
Brightness 0
Contrast 0
Color 0
Size 1000
Lamp1_Hours 0
Lamp2_Hours 0
Lamp1_Minutes 0
Lamp2_Minutes 0